VIVO Corner Clamp-on Under Desk Drawer and Shelf System, Office Accessory Holder for Supplies, Gaming Devices, and More, Multi-Level Storage, Workstation Organizer, Black

Very pleased; missing one screw
Just ordered and assembled these drawers. Like most “Ikea” type of installations, I had to undo some steps and re-do them. It took me about 2 hours to do. I listened to a podcast while doing it.I put it on my standing desk, but the desk has a part that is longer than the others. So it sits underneath that longer part, but it’ll work. I also have some parts of the desk assembly underneath it that impacts it from being completely flush with the desk. It’s not the drawer’s fault, but I thought it was important to note.I am missing one screw (S-A M4x16mm) that I have reached out to their support service about. I’m sure they’ll respond and send me the missing part (probably a whole bag of screws and parts).

Pasteboard rails – not sturdy
Easy to assemble and install. Beware of these “fake” receivers for the hangers. The receiver (finger) is just a “white metal” bit that was pressed into that tiny bit of pressboard. There’s no “feedback” that the fixture bolt is “in.” This that receiver pulls out and cannot be reinserted. Luckily, I changed side of the drawer and could use the other receiver (being much more cautious).

Janky with misplaced holes, but can be made to work
I assembled it perfectly to instructions and as with the review from “Eric” who reviewed it 1 star on January 8, 2024, the top drawer did not close. Luckily, I’m a handy tran, so I drilled another hole for the forward screw on both sides of the top drawer.Originally, the factory pre-drilled hole is for the furthest forward gap in the drawer slide (the leftmost oblong hole in the drawer slide in the picture). However, that hole was too low for me, so I unscrewed the forward screw on either side, slide the drawer in properly, pulled it out just enough to see the second hole (where the screw is in the picture), marked where that gap was using a scraper (although a felt pen would have worked just as well), and then drilled a new hole for the screw using a 3/32″ drill bit about 1/4″ in. However, I found the depth by inserting the bit into the existing hole until it reached the end, then wrapped some painter’s tape around the part of the bit that was still showing, in order to provide a guide – it may not be exactly 1/4″ so please measure it yourself before following my lead.That all said, when the new hole was in and I put the screw in as pictured, it fit perfectly, and also had more room for adjustment were adjustment needed.The product should come correct from the factory, and $70 is a steep price for this as is, so only 2 stars. But now that I fixed it, it works, so I won’t give it only one.I’d just say, if you’re not handy, look elsewhere for solutions for your needs before purchasing this product.

Fits well
Bought it for my husband and his desk. He says it was easy to put on and fits great.

The product is made out of cheap material and it is really fragile. It is like buying an IKEA product but 3 times lower in quality. Also there should be a competition called “make the drawers align”. It is simply not possible. I had to open new holes and after a lot of effort, now they are ….. better than before. But in all honestly it costs only 99 CAD and if it lasts for a year i will be happy.